Siemens RUGGEDCOM ROX II User Manual page 758

Chapter 16
Traffic Control and Classification
1. Make sure the CLI is in Configuration mode.
2. Delete the QoS map for the VLAN connection by typing:
• For Switched Ethernet Ports
no switch vlans all-vlans id qosmap priority egress mark
Where:
▫ id is the ID given to the VLAN
▫ priority is the priority assigned to the QoS map
▫ mark is the value of the egress mark
• For Routable-Only Ethernet Ports
no interface eth slot port vlan id qosmap priority egress mark
Where:
▫ slot is the name of the module location
▫ port is the port number (or a list of ports, if aggregated in a port trunk) for the module
▫ id is the ID given to the VLAN
▫ priority is the priority assigned to the QoS map
▫ mark is the value of the egress mark
• For Virtual Switches
no interface virtualswitch id vlan vlan-id qosmap priority egress mark
Where:
▫ slot is the name of the module location
▫ port is the port number (or a list of ports, if aggregated in a port trunk) for the module
▫ id is the ID given to the VLAN
▫ priority is the priority assigned to the QoS map
▫ mark is the value of the egress mark
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 16.2.9
Viewing QoS Statistics
RUGGEDCOM ROX II provides statistics for traffic going through each class that has been configured. Packets
are assigned to classes on the outbound interface based on rules. If a packet matches the specified criteria, it is
considered to be a member of the class and is forwarded to that class. If the packet does not match any rule, it is
forwarded to the default class.
For more information about traffic control classes, refer to
NOTE
Statistics are only available when traffic control is enabled in advanced mode. For more information
about enabling traffic control, refer to
To view the QoS statistics, type:
show qos statistics
712
Section 16.2.4, "Managing Traffic Control
Section 16.2.1, "Enabling and Configuring Traffic
RUGGEDCOM ROX II
CLI User Guide
Classes".
Control".
Viewing QoS Statistics