Siemens RUGGEDCOM ROX II User Manual page 547

RUGGEDCOM ROX II
CLI User Guide
Section 13.8.9.2
Adding an Aggregate Address Option
To add an option for an aggregate address, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the path by typing:
routing bgp aggregate-address address options [ summary-only | as-set ]
Where:
• address is the subnet address and prefix for the aggregate address
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.8.9.3
Deleting an Aggregate Address Option
To delete an option for an aggregate address, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the option by typing:
no routing bgp aggregate-address address options [ summary-only | as-set ]
Where:
• address is the subnet address and prefix for the aggregate address
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.8.10
Managing Redistribution Metrics
Redistribution metrics redistribute routing information from other routing protocols, static routes or routes
handled by the kernel. Routes for subnets that are directly connected to the router, but not part of the BGP
network, can also be advertised.
CONTENTS
• Section 13.8.10.1, "Viewing a List of Redistribution Metrics"
• Section 13.8.10.2, "Adding a Redistribution Metric"
• Section 13.8.10.3, "Deleting a Redistribution Metric"
Section 13.8.10.1
Viewing a List of Redistribution Metrics
To view a list of redistribution metrics for dynamic BGP routes, type:
show running-config routing bgp redistribute
If metrics have been configured, a table or list similar to the following example appears:
Adding an Aggregate Address Option
Chapter 13
Unicast and Multicast Routing
501