Siemens RUGGEDCOM ROX II User Manual page 524

Chapter 13
Unicast and Multicast Routing
no routing rip redistribute [ bgp | ospf | connected | static | kernel ]
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 13.7.11
Managing Routing Interfaces
This section describes how to manage interfaces for RIP routes.
CONTENTS
• Section 13.7.11.1, "Viewing a List of Routing Interfaces"
• Section 13.7.11.2, "Configuring a Routing Interface"
Section 13.7.11.1
Viewing a List of Routing Interfaces
To view a list of routing interfaces for a RIP network, type:
show running-config routing rip interface
A table or list similar to the following example appears:
ruggedcom# show running-config routing rip interface | tab
IFNAME MODE
----------------------------------------------------------------------
dummy0 -
fe-cm-1 -
switch.0001 -
Section 13.7.11.2
Configuring a Routing Interface
To configure a routing interface for a RIP network, do the following:
NOTE
OSPF regards router interfaces as either passive or active, sending OSPF messages on active interfaces
and ignoring passive interfaces.
1. Make sure the CLI is in Configuration mode.
2. Navigate to routing » rip » interface » {name}, where {name} is the name of the interface.
3. Configure the authentication settings by typing the following commands:
Parameter
mode { mode }
key-chain { key-chain }
478
KEY
CHAIN STRING PASSIVE
- - -
- - -
- - -
Synopsis: { md5-rfc, md5-old-ripd, text, none }
The authentication mode.
Synopsis: A string
RECEIVE SEND SPLIT
VERSION VERSION HORIZON
- - yes
- - yes
- - yes
Description
Managing Routing Interfaces
RUGGEDCOM ROX II
CLI User Guide