Siemens RUGGEDCOM ROX II User Manual page 722

Chapter 15
Network Discovery and Management
• name is the name of the community
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 15.2.6
Managing SNMP Target Addresses
This section describes how to manage SNMP target addresses.
CONTENTS
• Section 15.2.6.1, "Viewing a List of SNMP Target Addresses"
• Section 15.2.6.2, "Adding an SNMP Target Address"
• Section 15.2.6.3, "Deleting an SNMP Target Address"
Section 15.2.6.1
Viewing a List of SNMP Target Addresses
To view a list of SNMP target addresses configured on the device, type:
show running-config admin snmp snmp-target-address
If target addresses have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config admin snmp snmp-target-address | tab
TARGET NAME
--------------------------------------------------------------------------------
127.0.0.1 v1
127.0.0.1 v2
127.0.0.1 v3.guest
127.0.0.1 v3.inform
127.0.0.1 v3.trap
target
!
!
If no SNMP target addresses have been configured, add target addresses as needed. For more information, refer to
Section 15.2.6.2, "Adding an SNMP Target
Section 15.2.6.2
Adding an SNMP Target Address
To add an SNMP target address, do the following:
1. Make sure the CLI is in Configuration mode.
Navigate to admin » snmp » snmp-target-address and configure the following parameter(s) as required:
2.
Parameter
{ target-name }
676
TARGET
ENABLED ADDRESS
true 127.0.0.1
true 127.0.0.1
true 127.0.0.1
true 127.0.0.1
true 127.0.0.1
true 192.168.0.111
Address".
Synopsis: A string 1 to 32 characters long
TRAP SECURITY USER
PORT MODEL NAME
162 v1 oper
162 v2c oper
162 v3 admin
162 v3 admin
162 v3 admin
162 v2c admin
Description
SECURITY
LEVEL
noAuthNoPriv
noAuthNoPriv
noAuthNoPriv
authPriv
authNoPriv
noAuthNoPriv
Managing SNMP Target Addresses
RUGGEDCOM ROX II
CLI User Guide