Siemens RUGGEDCOM ROX II User Manual page 394

Chapter 10
Serial Server
ruggedcom# show running-config interface serial protocols rawsocket setrawsocket remote-host
interface
serial lm5 1
no alias
protocols rawsocket
setrawsocket local-port 30001
setrawsocket transport udp
setrawsocket remote-host 1.1.1.2 60001
!
setrawsocket remote-host 232.1.1.1 60001
interface switch.0010
!
!
!
!
!
!
If no remote hosts have been configured, add hosts as needed. For more information, refer to
"Adding a Remote Host".
Section 10.5.2
Adding a Remote Host
To add a remote host for a serial port using the raw socket protocol, do the following:
NOTE
A maximum of two multicast remote host entries are permitted per serial interface.
1. Make sure the CLI is in Configuration mode.
2. Add the remote host by typing:
interface serial slot port protocols rawsocket setrawsocket remote-host address remote-port
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
• address is the IP address for the remote host or a multicast group IP address for which the interface is a
source
• remote-port is the port number for the remote host
3. Configure the following parameter(s) as required:
Parameter
loopback
4. [Optional] Add a remote host interface. For more information, refer to
Interface".
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
5.
348
Synopsis: { true, false }
Default: false
Enables transmitting to the loopback interface with the destination multicast group IP
address and remote port. Matching local hosts with loopback enabled will receive the
transmitted data.
Section 10.5.2,
Description
Section 10.7.2, "Adding a Remote Host
Adding a Remote Host
RUGGEDCOM ROX II
CLI User Guide