Siemens RUGGEDCOM ROX II User Manual page 727

RUGGEDCOM ROX II
CLI User Guide
2. Add the SNMP security model by typing:
admin snmp snmp-security-to-group model name { group | group }
Where:
• model is the security model. Options include range, v1, v2c and v3.
• name is the name of the associated user profile. Options include admin, guest and oper.
• group is the name of the associated SNMP group. If a group is not defined, the user is granted all access
rights by default.
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 15.2.8.3
Deleting an SNMP Security Model
To delete an SNMP security model, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the SNMP security model by typing:
no admin snmp snmp-security-to-group model name
Where:
• model is the security model
• name is the name of the associated user profile
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 15.2.9
Managing SNMP Group Access
This section describes how to manage access for SNMP groups.
CONTENTS
• Section 15.2.9.1, "Viewing a List of SNMP Groups"
• Section 15.2.9.2, "Adding an SNMP Group"
• Section 15.2.9.3, "Deleting an SNMP Group"
Section 15.2.9.1
Viewing a List of SNMP Groups
To view a list of SNMP groups configured on the device, type:
show running-config admin snmp snmp-access
If groups have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config admin snmp snmp-access | tab
SECURITY
Deleting an SNMP Security Model
SECURITY READ VIEW WRITE VIEW NOTIFY
Network Discovery and Management
Chapter 15
681