Siemens RUGGEDCOM ROX II User Manual page 343

RUGGEDCOM ROX II
CLI User Guide
Section 8.4.3.3
Adding a Router Port
To add a router port for IGMP snooping, do the following:
1. Make sure the CLI is in Configuration mode.
2. Add the router port by typing:
switch mcast-filtering igmp-snooping router-ports slot port
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 8.4.3.4
Deleting a Router Port
To delete a router port for IGMP snooping, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the router port by typing:
no switch mcast-filtering igmp-snooping router-ports slot port
Where:
• slot is the name of the module location
• port is the port number (or a list of ports, if aggregated in a port trunk) for the module
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 8.4.4
Managing the Static Multicast Group Table
This section describes how to manage entries in the Static Multicast Group table.
CONTENTS
• Section 8.4.4.1, "Viewing a List of Static Multicast Group Entries"
• Section 8.4.4.2, "Adding a Static Multicast Group Entry"
• Section 8.4.4.3, "Deleting a Static Multicast Group Entry"
Section 8.4.4.1
Viewing a List of Static Multicast Group Entries
To view a list of entries for known static multicast groups on other devices, type:
show running-config switch mcast-filtering static-mcast-table
Adding a Router Port
Chapter 8
Layer 2
297