Siemens RUGGEDCOM ROX II User Manual page 142

Chapter 4
Device Management
Parameter
admin-enabled
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 4.17
Managing SFP Transceivers (RUGGEDCOM RX5000
Only)
RUGGEDCOM ROX II supports a wide variety of Small Form-factor Pluggable (SFP) transceivers to help expand
the capabilities of the device. For a full list of Siemens-approved SFP transceivers, refer to the
Transceivers Catalog
IMPORTANT!
It is strongly recommended to use SFP transceiver models approved by Siemens only. Siemens performs
extensive testing on these transceivers to make sure they can withstand harsh conditions. If a different
SFP transceiver model is used, it is the user's responsibility to verify it meets environmental and usage
requirements.
CONTENTS
• Section 4.17.1, "SFP Transceiver Support"
• Section 4.17.2, "Viewing SFP Information"
• Section 4.17.3, "Enabling/Disabling Smart SFP Mode (RUGGEDCOM RX5000 Only)"
Section 4.17.1
SFP Transceiver Support
RUGGEDCOM ROX II offers the following support for SFP transceivers.
Hot Swappable
All SFP transceivers are hot swappable, meaning they can be removed and inserted while the device is operating.
Only a previously established link on that port is affected while the socket is empty.
Automatic Detection
RUGGEDCOM ROX II actively monitors each SFP transceiver port to determine when an SFP transceiver has been
inserted or removed. Each event triggers an alarm and is logged in the syslog.
Smart SFP For Select Transceivers
Smart SFP mode is available for any port on the RUGGEDCOM RX1500PN LM 4FG50 line module. This mode is
enabled by default.
96
Sets the administrative state for a module. Enabling the module powers it on.
[https://support.industry.siemens.com/cs/ww/en/view/109482309].
Description
Managing SFP Transceivers (RUGGEDCOM RX5000 Only)
RUGGEDCOM ROX II
CLI User Guide
RUGGEDCOM SFP