Chapter 17
Time Services
Section 17.8.5.2
Adding a Server Key
To add a server key, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Add the key by typing:
services ntp key id
Where:
• id is the ID assigned to the key
3.
Configure the following parameter(s) as required:
Parameter
value { value }
trusted
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
4.
Section 17.8.5.3
Deleting a Server Key
To delete a server key, do the following:
1.
Make sure the CLI is in Configuration mode.
2.
Delete the chosen key by typing:
no services ntp key id
Where:
• id is the ID assigned to the key
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 17.8.6
Managing Server Restrictions
Server restrictions control access to the NTP servers.
CONTENTS
•
Section 17.8.6.1, "Viewing a List of Server Restrictions"
•
Section 17.8.6.2, "Adding a Server Restriction"
•
Section 17.8.6.3, "Deleting a Server Restriction"
738
Synopsis: A string 1 to 1024 characters long
The key.
This parameter is mandatory.
Mark this key as trusted for the purposes of authenticating peers with symmetric key
cryptography. The authentication procedures require that both the local and remote
servers share the same key and key identifier.
Description
Adding a Server Key
RUGGEDCOM ROX II
CLI User Guide