Siemens RUGGEDCOM ROX II User Manual page 288

Chapter 7
IP Address Assignment
6. [Optional] Configure configuration options for DHCP clients at the host group level. For more information,
refer to refer to
Section 7.3.5.2, "Configuring Standard DHCP Client Configuration Options
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
7.
Section 7.3.9.4
Deleting a Host Group
To delete a host group, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the host group by typing:
• For IPv4
no services dhcpserver host-groups name
• For IPv6
no services dhcpserver6 host-groups name
Where:
• name is the name of the host group
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 7.3.10
Managing DHCP Hosts
Host entries assign settings to a specific client based on its Ethernet MAC address.
CONTENTS
• Section 7.3.10.1, "Viewing a List of Hosts"
• Section 7.3.10.2, "Adding a Host"
• Section 7.3.10.3, "Configuring Host Options"
• Section 7.3.10.4, "Deleting Hosts"
Section 7.3.10.1
Viewing a List of Hosts
To view a list of hosts on the DHCP server, type:
• For IPv4
show running-config services dhcpserver host
242
Parameter
The subnet that this host belongs to.
Section 7.3.5.1, "Configuring Standard DHCP Client Configuration Options (IPv4)"
Description
(IPv6)".
Deleting a Host Group
RUGGEDCOM ROX II
CLI User Guide
or