Siemens RUGGEDCOM ROX II User Manual page 410

Chapter 12
Tunneling and VPNs
Section 12.1.5.4
Deleting a Virtual Switch Filter
To delete a virtual switch filter, do the following:
1. Make sure the CLI is in Configuration mode.
2. Delete the virtual switch filter by typing:
no security virtualswitch-filter virtualswitch name
Where:
• name is the name of the virtual switch filter
Type commit and press Enter to save the changes, or type revert and press Enter to abort.
3.
Section 12.1.6
Managing Filtering Rules
A virtual switch filter can apply one or more rules to traffic traversing a virtual switch.
CONTENTS
• Section 12.1.6.1, "Viewing a List of Rules"
• Section 12.1.6.2, "Viewing a List of Rules Assigned to a Virtual Switch Filter"
• Section 12.1.6.3, "Adding a Rule"
• Section 12.1.6.4, "Adding a Rule to a Virtual Switch Filter"
• Section 12.1.6.5, "Deleting a Rule"
• Section 12.1.6.6, "Deleting a Rule from a Virtual Switch Filter"
Section 12.1.6.1
Viewing a List of Rules
To view a list of rules that can be used by a virtual switch filter, type:
show running-config security virtualswitch-filter rules
If rules have been configured, a table or list similar to the following example appears:
ruggedcom# show running-config security virtualswitch-filter rules | tab
NAME ACTION SRCMAC
-------------------------------------------------------------
arp accept -
goose accept 00:00:00:00:11:11
ipv4 accept 00:00:00:00:00:01
ipv6 accept -
iso accept -
!
!
If no rules have been configured, add rules as needed. For more information, refer to
Rule".
364
DSTMAC PROTO
- arp
01:0c:cd:01:00:33 0x88b8
00:00:00:00:00:02 ipv4
- ipv6
- iso
RUGGEDCOM ROX II
CLI User Guide
Section 12.1.6.3, "Adding a
Deleting a Virtual Switch Filter