Rep 1.20 Output Tray Full Sensor - Xerox WorkCentre 3215 Service Manual

REP 1.20 Output Tray Full Sensor

Parts List on PL 4.5
Removal
1. Switch Off the Printer and disconnect the Power Cord.
2. Remove the Middle Cover (REP 1.3).
NOTE: Do not disconnect the connectors to the Main PWB. The PWB only needs to be moved
away from the frame to access the Output Tray Full Sensor.
NOTE: Mark the location of the Ground Screw, with larger head, so it can be re-installed in the
correct location.
3. Remove the screws (5) to move the Main PWB away from the printer frame
Figure 1 Main PWB
4. Remove the Output Tray Full Sensor
a. Disconnect the Sensor connector.
b. Unlatch and remove the Output Tray Sensor.
Xerox® WorkCentre® 3215/3225 Multifunction Printer Service Manual
(Figure
(Figure 2):
1).
Figure 2 Output Tray Full Sensor (Top Right View)
Replacement
NOTE: Tapered Plastic Screws and Round Machine Screws are used to hold the Fuser to the
frame. Make sure that the Plastic Screws go into plastic components and Machine Screws go
into the metal frame.
Install the components in the reverse of removal.
June 2014
4-31
Output Tray Full Sensor
Repairs
REP 1.20, REP 1.21