Figure 2 Exit Sensor Removal (Rear View)
Replacement
Install the components in the reverse of removal.
Repairs
REP 1.19, REP 1.20
REP 1.20 Output Tray Full Sensor
Parts List on PL 4.3
Removal
1.
Switch Off the Printer and disconnect the Power Cord.
2.
Remove the following covers:
a.
b.
c.
NOTE: Do not disconnect the connectors to the Main PWB. The PWB only needs to be moved
away from the frame to access the Output Tray Full Sensor.
NOTE: Mark the location of the Ground Screw, with larger head, so it can be re-installed in the
correct location.
Exit Sensor
3.
Remove the screws (5) to move the Main PWB away from the printer frame
4.
Remove the Output Tray Full Sensor
a.
b.
June 2014
4-30
Remove the Left and Right Side Covers
Remove the Rear Cover
(REP
1.4).
Remove the Top Cover
(REP
1.3).
Main PWB
Figure 1 Main PWB
(Figure
Disconnect the Sensor connector.
Unlatch and remove the Output Tray Sensor.
Xerox® Phaser® 3052/3260 Service Manual
(REP
1.2).
(Figure
1).
2):