D-Link DXS-3600 Series Reference Manual page 1183

DXS-3600 Series Layer 3 Managed 10Gigabit Ethernet Switch CLI Reference Guide
SEVERITY-NAME
discriminator
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
The system messages can be logged to the local message buffer, local console or other destinations.
Messages must enter the local message buffer first before it can further be dispatched to the console.
This command does not take effect if the specified discriminator does not exist. Thus the default setting of
the command is applied.
Specify the severity level of the messages in order to restrict the system messages that are logged to the
console. The messages which are at the specified severity level or higher will be dispatched to the local
console.
Example
This example shows how to enable the logging of messages to the local console and restrict the logging
of messages with a security level of errors or higher.
Switch# configure terminal
Switch(config)# logging console severity errors
Switch(config)#
104-4 logging discriminator
This command is used to create a discriminator that can be further used to filter SYSLOG messages sent
to various destinations.
logging discriminator NAME [facility {drops STRING | includes STRING}] [severity {drops
SEVERITY-LIST | includes SEVERITY-LIST}]
no discriminator NAME
Parameters
NAME
facility
STRING
the local console. This value must be between 0 and 7. 0 is the most
severe level. If not specified, the default severity level is warnings (4).
(Optional) Specifies the severity level of system messages by one of
the following names: emergencies, alerts, critical, errors, warnings,
notifications, informational, debugging.
(Optional) Specifies to filter the message to be sent to the local
console based on the discriminator.
Specifies the name of the discriminator.
(Optional) Specifies a sub-filter based on the facility string.
Specifies one or more facility names. If multiple facility names are
used, they should be separated by commas without spaces before and
after the comma.
1183