Configuring Aggregated Ethernet Minimum Links - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Configuring Aggregated Ethernet Minimum Links

Copyright © 2010, Juniper Networks, Inc.
different from the speed you specify in the
be logged.
To set the required link speed:
Specify that you want to configure the aggregated Ethernet options.
1.
user@host# edit interfaces interface-name aggregated-ether-options
Configure the link speed.
2.
[edit interfaces interface-name aggregated-ether-options ]
user@host# set link-speed speed
can be in bits per second either as a complete decimal number or as a decimal
speed
number followed by the abbreviation
Aggregated Ethernet interfaces on the M120 router can have one of the following
speed values:
—Links are 100 Mbps.
100m
10g —Links are 10 Gbps.
—Links are 1 Gbps.
1g
OC192 —Links are OC192 or STM64c.
Aggregated Ethernet links on EX Series switches can be configured to operate at one
of the following speeds:
10m
100m
1g
10g
50g
On aggregated Ethernet interfaces, you can configure the minimum number of links that
must be up for the bundle as a whole to be labeled
up for the bundle to be labeled
To configure the minimum number of links:
Specify that you want to configure the aggregated Ethernet options.
1.
user@host# edit interfaces interface-name aggregated-ether-options
Configure the minimum number of links.
2.
[edit interfaces interface-name aggregated-ether-options]
user@host# set minimum-links number
parameter, an error message will
link-speed
k (1000), m (1,000,000), or
up . By default, only one link must be
.
up
Chapter 58: Configuring Interfaces
g (1,000,000,000).
1337