Example: Qos Parameter Configuration For Hierarchical Parameters; Procedure For Qos Administrators; Figure 62: Hierarchical Parameters Scheduler Hierarchy - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - QUALITY OF SERVICE CONFIGURATION GUIDE 2010-09-22 Configuration Manual

Related
Documentation

Example: QoS Parameter Configuration for Hierarchical Parameters

Procedure for QoS Administrators

Copyright © 2010, Juniper Networks, Inc.
Include the hierarchical keyword with the qos-parameter-define command.
host1(config)#qos-parameter-define max-subscriber-bandwidth
host1(config-qos-parameter-define)#
Hierarchical QoS Parameters Overview on page 245
Configuring a Basic Parameter Definition for QoS Administrators on page 223
Configuring a Parameter Definition for IP Multicast Bandwidth Adjustment on page 255
Example: QoS Parameter Configuration for Hierarchical Parameters on page 247
qos-parameter-define
The example in this section illustrates how to configure hierarchical parameters for VLANs
and S-VLANs.
Figure 62 on page 247 shows the QoS scheduler hierarchy that the QoS client creates for
the VLANs and S-VLANs in the interface stack. The QoS client creates explicit parameter
instances using the parameter definition max-sub-bw to shape rates at the VLAN
subinterfaces 100 and 101.
An S-VLAN node is located below the two VLAN nodes in the interface stack. The QoS
client creates an implicit parameter instance by applying a shaper to the S-VLAN
subinterface 10 that equals the total rate at the VLANs (3072000).

Figure 62: Hierarchical Parameters Scheduler Hierarchy

This section describes the procedures to configure the scheduler hierarchy shown in
Figure 62 on page 247 by using QoS parameters.
Chapter 26: Configuring Hierarchical QoS Parameters
247