Virtual Chassis Port (Vcp) Connection Does Not Work; Switches - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Complete Software Guide for Junos
Cause
Solution
Related
Documentation
Troubleshooting Uplink Module Installation or Replacement on EX4200 Switches

Virtual Chassis port (VCP) connection does not work

Problem
Cause
Solution
Related
Documentation
1358
®
OS for EX Series Ethernet Switches, Release 10.4
The uplink module installed in the switch was replaced.
Set a port in the uplink module as a VCP. See "Setting an EX4200 Switch Uplink Module
Port as a Virtual Chassis Port (CLI Procedure)" on page 994.
Monitoring Interface Status and Traffic on page 1345
Configuring Gigabit Ethernet Interfaces (CLI Procedure) on page 1284
Configuring Gigabit Ethernet Interfaces (J-Web Procedure) on page 1287
Installing an Uplink Module in an EX4200 Switch
Removing a Transceiver from an EX Series Switch
Uplink Modules in EX4200 Switches
Understanding Virtual Chassis Hardware Configuration on an EX4200 Switch
This topic provides troubleshooting information for specific problems related to uplink
module ports on EX4200 switches.
Virtual Chassis port (VCP) connection does not work on page 1358
1.
The Virtual Chassis port (VCP) connection configured in an EX4200 switch does not
work.
A port of the uplink module is set as a VCP.
The uplink module installed in the switch was replaced.
Set a port in the uplink module as a VCP. See "Setting an EX4200 Switch Uplink Module
Port as a Virtual Chassis Port (CLI Procedure)" on page 994.
Monitoring Interface Status and Traffic on page 1345
Configuring Gigabit Ethernet Interfaces (CLI Procedure) on page 1284
Configuring Gigabit Ethernet Interfaces (J-Web Procedure) on page 1287
Installing an Uplink Module in an EX4200 Switch
Removing a Transceiver from an EX Series Switch
Uplink Modules in EX4200 Switches
Understanding Virtual Chassis Hardware Configuration on an EX4200 Switch
Copyright © 2010, Juniper Networks, Inc.