Lacp (Aggregated Ethernet) - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

lacp (Aggregated Ethernet)

Syntax
Hierarchy Level
Release Information
Description
Default
Options
Required Privilege
Level
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
lacp mode{
(active | passive);
admin-key key;
link-protection {
disable;
(revertive |non-revertive);
}
periodic interval;
system-id mac-address;
system-priority priority;
}
[edit interfaces aex aggregated-ether-options]
Statement introduced before Junos OS Release 7.4.
Statement introduced in Junos OS Release 9.0 for EX Series switches.
For aggregated Ethernet interfaces only, configure Link Aggregation Control Protocol
(LACP).
If you do not specify
LACP
mode—LACP mode:
—Initiate transmission of LACP packets.
active
passive —Respond to LACP packets.
The remaining statements are explained separately.
interface—To view this statement in the configuration.
interface-control—To add this statement to the configuration.
Configuring Aggregated Ethernet LACP
Configuring Aggregated Ethernet LACP (CLI Procedure) on page 1334
Example: Configuring Aggregated Ethernet High-Speed Uplinks with LACP Between
an EX4200 Virtual Chassis Access Switch and an EX4200 Virtual Chassis Distribution
Switch on page 947
Chapter 61: Configuration Statements for Interfaces
as either active or passive, LACP remains passive.
1401