Table 204: Aggregated Ethernet Interface Options - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Complete Software Guide for Junos

Table 204: Aggregated Ethernet Interface Options

Field
Aggregated Interface
LACP Mode
Description
1332
®
OS for EX Series Ethernet Switches, Release 10.4
NOTE: After you make changes to the configuration in this page, you must
commit the changes immediately for them to take effect. To commit all
changes to the active configuration, select
Using the Commit Options to Commit Configuration Changes for details
about all commit options.
Click one of the following:
2.
Add —Creates an aggregated Ethernet interface, or LAG. Enter information as
specified in Table 204 on page 1332.
—Modifies a selected LAG.
Edit
Aggregation —Modifies settings for the selected LAG. Enter information as specified
in Table 204 on page 1332.
—Specifies VLAN options for the selected LAG. Enter information as specified
VLAN
in Table 205 on page 1333.
—Specifies IP options for the selected LAG. Enter information as specified
IP Option
in Table 206 on page 1333.
Delete —Deletes the selected LAG.
or
Disable Port Enable Port
selected interface.
Device Count —Configures the number of aggregated logical devices available to
the switch. Select the number and click
Function
Specifies the name of the aggregated
interface.
Specifies the mode in which LACP
packets are exchanged between the
interfaces. The modes are:
—Indicates that no mode is
None
applicable.
—Indicates that the interface
Active
initiates transmission of LACP packets
—Indicates that the interface
Passive
responds only to LACP packets.
Specifies a description for the LAG.
Commit Options
—Disables or enables the administrative status on the
.
OK
Your Action
None. The name is supplied by the
software.
Select from the list.
Enter a description.
Copyright © 2010, Juniper Networks, Inc.
> . See
Commit