New Holland T8010 Manual page 1360

C - First Circuit Test (Mirror Switch Connector 130 to In-line Connector 111
Test point
1 Remove connector 130
from power mirror switch.
Disconnect in-line
connector 111M from in-
line connector 111F.
Set DVOM to test
continuity.
Check for continuity
between connector 111F
terminal 1 and connector
130 terminal 8.
2 Check for continuity
between connector 111F
terminal 2 and connector
130 terminal 7.
3 Check for continuity
between connector 111F
terminal 2 and splice C6.
4 Check for continuity
between connector 111F
terminal 3 and connector
130 terminal 4.
5 Check for continuity
between connector 111F
terminal 4 and connector
130 terminal 10.
6 Check for continuity
between connector 111F
terminal 5 and connector
130 terminal 7.
7 Check for continuity
between connector 111F
terminal 6 and connector
130 terminal 5.
Section 55 - Electrical System - Chapter 1
Good Reading
Continuity
If good reading, go to next
test point.
Continuity
If good reading, go to test
point 4.
Continuity
If good reading, repair
open in 58B(O) circuit.
Continuity
If good reading, go to next
test point.
Continuity
If good reading, go to next
test point.
Continuity
If good reading, go to next
test point.
Continuity
If good reading, circuits
between connector 130
and in-line connector 111F
are okay
55-1-179
Possible Cause of Bad Reading
Open in 275A(O) circuit.
Open in circuit between connector 111F
terminal 2 and connector 130 terminal
7.
Go to next test point.
Open in 58B(O) circuit.
Open in 277A(O) circuit.
Open in 278A(O) circuit.
Open in 58(O) circuit.
Open in 280A(O) circuit.