New Holland T8010 Manual page 1418

Standard Instrumentation Configuration Is Incorrect
Cause:
This fault code is recorded if any controller is detected on the Data Bus but was not set to exist in the instrument
controller configuration menu.
Possible failure mode:
1. A controller is added to the Data Bus but the instrumentation controller is not recalibrated.
2. The standard instrumentation is calibrated without selecting all the controllers on the Data Bus.
Solution:
Repeat controller configuration for the instrument controller. Validate that all the correct controllers are set to exist.
If desired, use the AUTO menu selection. It will automatically set the controller configuration in the instrument
controller based on Data Bus information.
Engine shutdown activated
Cause:
This fault code is recorded if the engine shutdown is activated
Possible failure mode:
1. Engine shutdown was activated.
Solution:
See operator manual for more information regarding engine shutdown feature.
Memory Not Cleared From The Factory
Cause:
The instrumentation controller memory has not been cleared from the factory.
Solution:
This is a "non fault" fault. Clear the fault code from the controller.
Section 55 - Electrical System, Controller - Chapter 2
FAULT CODE INST 53001
FAULT CODE INST 53005
FAULT CODE INST 65535
55-2-33