New Holland T8010 Manual page 1390

Hide thumbs Also See for T8010:

Table of Contents

Section 55 - Electrical System, Controller - Chapter 2

3. Check the wiring from the instrumentation controller to the seat switch connector C133

There should be continuity from cavity 23 of connector C61 to cavity 6 of connector C133.

There should be 12 VDC power supply at the cavity 5 of connector C133.

NOTE: Always inspect connector ends for damaged, bent or dislocated pins when troubleshooting.

NOTE: See schematic section 67 on the schematic poster.

Chapters

Table of Contents

T8020 T8030 T8040