Fault Code Inst 13040 - New Holland T8010 Manual

Air Intake Temperature Sensor Failed in Engine Controller
Cause:
The Data Bus signaled that the air to air intake temperature data is in error or not available from the engine
controller.
Possible failure modes:
1. Air to air intake sensor failed in the engine controller.
2. The engine controller is configured in the instrumentation controller when there is no engine controller.
3. Software execution error in the engine controller.
Solution:
This fault code is for the tractors equipped with an engine controller. The instrumentation controller received the air
to air intake temperature signal from the engine controller through Data Bus.
1. Make sure the engine is running properly.
2. Recalibrate the instrumentation controller if there is no engine controller but the system was calibrated as with
the engine controller.
3. Refer to engine diagnosing procedures for air to air intake temperature fault troubleshooting.
NOTE: See schematic sections 24, 25 and 26 on the schematic poster.
Section 55 - Electrical System, Controller - Chapter 2

FAULT CODE INST 13040

55-2-30