Fault Code Inst 13010 - New Holland T8010 Manual

Engine Coolant Temperature Sensor Failed in Engine Controller
Cause:
The Data Bus signaled that engine coolant temperature data is in error or not available from the engine controller.
Possible failure modes:
1. Engine coolant temperature sensor failed in the engine controller.
2. The engine controller is configured into the instrumentation controller when there is no engine controller.
3. Software execution error in the engine controller.
Solution:
This fault code is for the tractors equipped with an engine controller. The instrumentation controller received the
coolant temperature signal from the engine controller though the Data Bus.
1. Make sure the engine is running properly.
2. Recalibrate the instrumentation cluster if there is no engine controller but the system was calibrated as with the
engine controller.
3. Refer to the engine diagnosing procedures for coolant temperature error troubleshooting.
Fault codes ENG 32, 33, 34, 35, 36, 109, and 119 are coolant temperature related.
Section 55 - Electrical System, Controller - Chapter 2

FAULT CODE INST 13010

55-2-25