New Holland T8010 Manual page 1361

D - Second Circuit Test (Mirror Assembly Connectors 112 and 113
Test point
1 Remove connector 112 from left
mirror assembly.
Disconnect in-line connector
111M from in-line connector
111F.
Set DVOM to test continuity.
Check for continuity between
connector 111M terminal 1 and
connector 112 terminal 3.
2 Check for continuity between
connector 111M terminal 2 and
connector 112 terminal 2.
3 Check for continuity between
connector 111M terminal 3 and
connector 112 terminal 1.
4 Remove connector 113 from
right mirror assembly.
Disconnect in-line connector
111M from in-line connector
111F.
Set DVOM to test continuity.
Check for continuity between
connector 111M terminal 4 and
connector 113 terminal 3.
5 Check for continuity between
connector 111M terminal 5 and
connector 113 terminal 2.
6 Check for continuity between
connector 111M terminal 6 and
connector 113 terminal 1.
Section 55 - Electrical System - Chapter 1
to In-line Connector 111)
Good Reading
Continuity
If good reading, go to
next test point.
Continuity
If good reading, go to
next test point.
Continuity
If good reading, circuits
between in-line
connector 111M and left
mirror connector 112
okay. Go to next test
point.
Continuity
If good reading, go to
next test point.
Continuity
If good reading, go to
next test point.
Continuity
If good reading, circuits
between in-line
connector 111M and
right mirror connector
113 okay.
55-1-180
Possible Cause of Bad Reading
Open in 949A(O) circuit.
Open in 950(DG) circuit.
Open in 951A(Y) circuit.
Open in 952A(O) circuit.
Open in 953A(DG) circuit.
Open in 954A(Y) circuit.