Table of Contents
Advertisement
Chapter 6 Start and monitor a run
6
Use the Run queue to monitor a run on the instrument
• To specify re-injections—Select an injection, then tap Edit & Re-inject. Change the settings
if needed, then tap Done.
IMPORTANT! The Edit & Re-inject button is inactive if you select more than one injection, a
spectral calibration, or an install run injection.
The re-injection is added to the list with
Updated run settings for the re-injection are displayed in orange.
• To add a cancelled injection back into the queue—Select a plate or one or more injections,
then tap Add to queue. This button is displayed only if one or more injections have been
cancelled, and is active only when a cancelled injection is selected.
Pause the instrument in the Run Queue screen
Note: You can also pause the run from the home screen (see "Pause the instrument in the home
screen"
on page
Remote Monitoring software (see "Pause the instrument from the Remote Monitoring screen, resume
from the instrument home screen"
1. In the home screen, tap
2. In the Run Queue screen, select a plate or an injection, then tap Actions4Pause instrument.
166
157), in instrument status (see "Check instrument status"
on page
Run queue.
SeqStudio
(Re-inject) or
193).
™
Flex Series Genetic Analyzer with Instrument Software v1.0 User Guide
(Re-inject with changes) icon.
on page
67), and in the
Advertisement
Table of Contents
Troubleshooting
