Table of Contents
Advertisement
Chapter 6 Start and monitor a run
6
Unlink a plate file
Unlink a plate file
If a plate position is linked to a plate file, the plate position displays information about the plate and the
run. If a plate position is not linked to a plate file, the plate position status displays Link a plate file. For
more information, see "Parts of the home screen"
There are two ways to unlink a plate file from a plate position when a run is complete.
• Remove the plate from the drawer. See "Unload a plate from the instrument"
• In the home screen, tap the position to unlink. The Plate tab is displayed. In any tab, tap
Actions4Unlink plate file.
Note: If you want to change the linked plate file before you start a run, tap Actions4Unlink plate file
in any of the Set Up Plate screens.
Processes that the instrument performs during a run
After you tap Start run, the instrument performs the following processes.
• Performs pre-run checks.
– If any pre-run checks do not pass, the software displays a message screen or a
alert). For more information, see "Pre-run check messages and plate alerts during a run"
page 146
Note: The instrument conditions messages that are displayed in the bottom right of the home
screen are not triggered by pre-run checks. For more information, see "Instrument conditions
in the home screen"
– If pre-run checks pass, the run starts.
• Changes the run status in the home screen and the Run Queue screen:
– If no other plate is running, changes the status to Running and displays the time remaining
until the run is complete.
– If another plate is running, changes the status to In queue and displays the estimated end time
until the run is complete. The estimated end time changes to Time remaining when the plate
run starts.
144
and "View alert and notification details"
on page
40.
SeqStudio
™
on page
36.
on page
Flex Series Genetic Analyzer with Instrument Software v1.0 User Guide
on page
139.
!
149.
(Plate
on
Advertisement
Table of Contents
Troubleshooting
