Displaying Status On The Lcd; Start Logging Function (*Manual Logging Mode Only, [Default = Enabled]); Figure 7: Odalog Status Screen; Figure 8: Start Logging Process - Thermo Scientific Odalog L2 Series User Manual

OdaLog® L2 – Gas Logger User Manual
To set the correct time and date, stop the logging function (only necessary if the instrument is in Manual
Logging mode - see Section 6.6), place the Instrument into IrDA mode (See Section 6.8.1), and set the clock
via the
OdaStat-G™ software package – for more information, refer to the "OdaStat-G Quick User Guide", or the
Help function in the software.

6.4. Displaying STATUS on the LCD

Press and hold the button until "STATUS" is displayed, then release the button. The display will cycle
through the "STATUS" screens as shown.

6.5. Start Logging Function (*Manual Logging Mode only, [Default = Enabled])

NOTE:
Press and hold the button down and continue holding as the screen displays "STATUS", then release the
button when "START LOG" is displayed. See note 2 below if "CLOCK not SEt" is shown when the button is
released.
The OdaLog® is now logging as confirmed by the flashing "LOGGING" symbol on the display and the LED"
s on either side of the display flashing once every 10 seconds (Default: Enabled - can be changed in the
OdaStat-G™ software).
P/N: 10-1000

Figure 7: Odalog status screen

HOLD BUTTON
Log can only be manually started/ stopped
when 'auto-log' is NOT enabled in the
Instrument Parameters in the OdaStat-G
software

Figure 8: Start logging process.

Revision G, January 2024
RELEASE
BUTTON
RELEASE
BUTTON
Page | 11