2. Tap Manual commands.
3. Select a command as needed, then tap Send command.
Run self tests to check touchscreen, speakers, microphone, and proximity
sensor
You can run these tests if you suspect that the touch screen is not responsive or if you cannot hear
responses from Alexa when you are using voice commands.
1. In the home screen, tap
2. Tap Start, then follow the instructions on the screens to complete the tests.
If any tests fail, contact Technical Support.
Power off or power on the instrument
Under normal circumstances, there is no need to power off the instrument. Power off only if instructed
to do so by a service representative or a procedure in this guide. For more information, see "Shut down,
move, and reactivate the instrument"
The power switch is located on the front panel.
1. Move the power switch to the off position.
2. Wait a few minutes, then move the power switch to the on position.
SeqStudio
™
Flex Series Genetic Analyzer with Instrument Software v1.0 User Guide
Actions4Support4Self test.
on page
381.
Appendix A Troubleshooting
Additional troubleshooting procedures
A
485