Thermo Scientific appliedbiosystems SeqStudio Flex Series User Manual page 47

Task
View the injection list
Change the order of plates and
injections
Select a plate or injections to run
next
Re-inject samples
Display results for a plate or
injection
Cancel injections
Pause the instrument
Resume a run (displayed only
when the instrument is paused)
SeqStudio ™ Flex Series Genetic Analyzer with Instrument Software v1.0 User Guide
About the SeqStudio
In the home screen, tap Run queue.
In the Run queue screen, press-drag
injection up or down in the list.
This button is active in the Run queue screen during a run only.
Tap a plate or injection, then tap Inject next.
In the Run queue screen, tap an individual injection, then tap Edit &
Re-inject. To inject with the same settings, tap Done. To inject with
different settings, change settings, then tap Done.
Note: If you select a spectral calibration or install run injection, the
Edit & Re-inject button is inactive. Re-injections are not permitted for
these run types.
Tap a plate row to display the plate view.
Tap an injection row, then tap View plate to display the
electropherogram view with analyzed data displayed by default.
Tap an injection, then tap Cancel injections. The status after cancelling
depends on when the cancel was done during the run.
• If you tap when the status is Running, the status changes to
Aborted.
• If you tap when the status is In queue, the status changes to
Cancelled.
Tap Actions4Pause instrument during a run only.
Tap Resume run at the top of the Run queue screen. You can also
resume a run from the home screen and the Instrument status screen.
Chapter 1 Product information
™ Flex Series Instrument Software v1.0
Action
(Move) to move a plate or
1
47