Enter Injection Properties - Thermo Scientific appliedbiosystems SeqStudio Flex Series User Manual

3. Tap the Plate tab at the top of the screen.
4. Proceed to "Enter injection properties"

Enter injection properties

After you tap the Plate tab in the create or view screen, the plate view is displayed with the first
injection group selected.
Note: Injection group refers to each set of 8 or 24 wells on the plate, based on instrument
configuration.
1. Select additional injection groups as needed.
• Tap a well to select a single injection group.
• Press-drag to select multiple injection groups or the entire plate.
• Tap
Note: All settings in the remaining steps will be assigned to all selected injection groups. If
different injection groups require different settings, repeat these steps for each injection group.
SeqStudio ™ Flex Series Genetic Analyzer with Instrument Software v1.0 User Guide
(Select/deselect) at the top left of the plate to select or deselect all wells on the plate.
Chapter 4 Create a plate file on the instrument
on page 89.
4
Enter injection properties
89