Siemens SINAMICS S110 List Manual page 668

Parameter
List of parameters
Value: 0:
1:
2:
3:
4:
5:
6:
7:
8:
9:
9999: Do not calculate
p20081 NOT 0 run sequence / NOT 0 RunSeq
CU_S110-CAN, Can be changed: T
CU_S110-DP,
Data type: Unsigned16
CU_S110-PN,
P-Group: -
SERVO_S110-CAN
Not for motor type: -
(FBLOCKS),
SERVO_S110-DP
(FBLOCKS),
SERVO_S110-PN
(FBLOCKS)
Min
0
Description: Setting parameter for the run sequence of instance NOT 0 within the run-time group set in p20080.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
p20082 BI: NOT 1 input I / NOT 1 input I
CU_S110-CAN, Can be changed: T
CU_S110-DP,
Data type: Unsigned32 / Binary
CU_S110-PN,
P-Group: -
SERVO_S110-CAN
Not for motor type: -
(FBLOCKS),
SERVO_S110-DP
(FBLOCKS),
SERVO_S110-PN
(FBLOCKS)
Min
-
Description: Sets the signal source of input quantity I of instance NOT 1 of the inverter.
r20083 BO: NOT 1 inverted output / NOT 1 inv output
CU_S110-CAN,
Can be changed: -
CU_S110-DP,
Data type: Unsigned32
CU_S110-PN,
P-Group: -
SERVO_S110-CAN
Not for motor type: -
(FBLOCKS),
SERVO_S110-DP
(FBLOCKS),
SERVO_S110-PN
(FBLOCKS)
Min
-
Description: Display parameter for the inverted output of instance NOT 1 of the inverter.
1-668
Run-time group 0
Run-time group 1
Run-time group 2
Run-time group 3
Run-time group 4
Run-time group 5
Run-time group 6
Run-time group 7
Run-time group 8
Run-time group 9
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
32000
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
-
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
-
© Siemens AG 2012 All Rights Reserved
SINAMICS S110 List Manual (LH7), 06/2012, 6SL3097-4AP10-0BP3
Access level: 1
Func. diagram: 7216
Unit selection: -
Expert list: 1
Factory setting
160
Access level: 1
Func. diagram: 7216
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 1
Func. diagram: 7216
Unit selection: -
Expert list: 1
Factory setting
-