Siemens SINAMICS S110 List Manual page 528

Parameter
List of parameters
r8939 PN DAP ID / PN DAP ID
CU_S110-PN Can be changed: -
Data type: Unsigned32
P-Group: -
Not for motor type: -
Min
-
Description: Displays the PROFINET Device Access Point ID (DAP ID) for the onboard PROFINET interface.
The combination of device ID (r8909) and DAP ID uniquely identifies a PROFINET access point.
Note: List of the SINAMICS DAP IDs:
20005 hex: CBE20 V4.3
20006 hex: CBE20 V4.4
20106 hex: CU310-2 PN V4.4
20206 hex: CU305 PN V4.4
20306 hex: CU320-2 PN V4.4
r8955[0...5] CBE20 MAC Address of Station / CBE20 MAC addr
CU_S110-PN Can be changed: -
Data type: Unsigned8
P-Group: -
Not for motor type: -
Min
-
Description: Displays the MAC address for the Communication Board Ethernet 20 (CBE20).
p9210 Flashing component number / Flash comp_no.
CU_S110-CAN, Can be changed: U, T
CU_S110-DP,
Data type: Unsigned16
CU_S110-PN
P-Group: Topology
Not for motor type: -
Min
0
Description: Sets the component number for a component to get its status LED to flash.
Dependency: Refer to: p9211
p9211 Flash function / Flash fct.
CU_S110-CAN, Can be changed: U, T
CU_S110-DP,
Data type: Integer16
CU_S110-PN
P-Group: Topology
Not for motor type: -
Min
-1
Description: Sets the function for the component selected in p9210.
After initiating a function, the parameter is automatically reset again.
Example:
- Set the component number (p9210).
- Select the "flashing on" function (set p9211 = 1).
Value: -1:
0:
1:
Dependency: Refer to: p9210
1-528
Select function
Flashing off
Flashing on
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
-
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
-
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
499
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
1
© Siemens AG 2012 All Rights Reserved
SINAMICS S110 List Manual (LH7), 06/2012, 6SL3097-4AP10-0BP3
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-1