Siemens SINAMICS S110 List Manual page 478

Parameter
List of parameters
--> p5009 = 51 ... 53: fault values if the operation was not able to be successfully completed.
--> carry out a POWER ON (switch-off/switch-on).
Value: 0:
1:
2:
3:
5:
20:
40:
51:
52:
53:
Note: Help for fault value = 51 ... 53:
- repeat the operation.
p5016 Enable spindle commissioning / Enable comm
SERVO_S110-CAN, Can be changed: C2, T
SERVO_S110-DP,
Data type: Integer16
SERVO_S110-PN
P-Group: -
Not for motor type: -
Min
0
Description: Setting to enable/inhibit spindle commissioning.
Value: 0:
1:
Note: The parameter is automatically set to a value of 1 after exiting commissioning (p0009 = 0).
r7760 Write protection status / Write prot stat
All objects Can be changed: -
Data type: Unsigned16
P-Group: -
Not for motor type: -
Min
-
Description: Displays the status for write protection of adjustable parameters.
Bit field: Bit Signal name
00 Write protection active
Note: Write protection can be activated/deactivated via p7760 on the Control Unit.
p7761 Write protection / Write protection
CU_S110-CAN, Can be changed: U, T
CU_S110-DP,
Data type: Integer16
CU_S110-PN
P-Group: -
Not for motor type: -
Min
0
Description: Setting for activating/de-activating the write protection for adjustable parameters.
Value: 0:
1:
Note: The following parameters are excluded from the write protection:
- p0003 (BOP access level)
- p0971 (drive object save parameters)
- p0977 (save all parameters)
- p3950 (service parameters)
1-478
No function
Reset
Set invalid
Reserved
Set valid
Operation successfully completed.
Operation running
Function not supported
File access unsuccessful
Operation unsuccessful
Spindle commissioning enabled
Spindle commissioning inhibited
Inactive
Active
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
1
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
-
1 signal
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
1
© Siemens AG 2012 All Rights Reserved
SINAMICS S110 List Manual (LH7), 06/2012, 6SL3097-4AP10-0BP3
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
-
0 signal FP
-
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
0