Siemens SINAMICS S110 List Manual page 601

Dependency: Refer to: p9762
Note: The new password entered into p9762 must be re-entered in order to acknowledge.
p9762 = p9763 = 0 is automatically set after the new Safety Integrated password has been successfully acknowl-
edged.
r9765 SI Motion forced check procedure remaining time (Control Unit) / SI Mtn dyn remain
SERVO_S110-CAN, Can be changed: -
SERVO_S110-DP,
Data type: FloatingPoint32
SERVO_S110-PN
P-Group: Safety Integrated
Not for motor type: -
Min
- [h]
Description: Displays the time remaining until the next dynamization and testing of the safety motion monitoring functions inte-
grated in the drives.
The signal source to initiate the forced checking procedure is parameterized in p9705.
Dependency: Refer to: p9705
Refer to: C01798
r9770[0...3] SI vers. safety fcts that run indep. in the drive (processor 1) / SI version Drv P1
SERVO_S110-CAN, Can be changed: -
SERVO_S110-DP,
Data type: Unsigned16
SERVO_S110-PN
P-Group: Safety Integrated
Not for motor type: -
Min
-
Description: Displays the Safety Integrated version for the drive-integrated safety functions on processor 1.
Index: [0] = Safety Version (major release)
[1] = Safety Version (minor release)
[2] = Safety Version (baselevel or patch)
[3] = Safety Version (hotfix)
Dependency: Refer to: r9890
Note: Example:
r9770[0] = 2, r9770[1] = 60, r9770[2] = 1, r9770[3] = 0 --> Safety version V02.60.01.00
r9771 SI common functions (processor 1) / SI general fct P1
SERVO_S110-CAN, Can be changed: -
SERVO_S110-DP,
Data type: Unsigned32
SERVO_S110-PN
P-Group: Safety Integrated
Not for motor type: -
Min
-
Description: Displays the Safety Integrated monitoring functions supported on processor 1 and processor 2.
Processor 1 determines this display.
Bit field: Bit Signal name
00 STO supported via terminals
01 SBC supported
02 Extended Functions supported (p9501 > 0)
03 SS1 supported
04 Extended Functions PROFIsafe supported
05 Extended Functions integrated in drive sup-
ported (p9601.2 = 1)
06 Basic Functions PROFIsafe supported
07 Extended Functions encoderless supported Yes
08 Safe Brake Adapter supported
© Siemens AG 2012 All Rights Reserved
SINAMICS S110 List Manual (LH7), 06/2012, 6SL3097-4AP10-0BP3
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
- [h]
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
-
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
-
1 signal
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Parameter
List of parameters
Access level: 3
Func. diagram: -
Unit selection: -
Expert list: 1
Factory setting
- [h]
Access level: 3
Func. diagram: 2802
Unit selection: -
Expert list: 1
Factory setting
-
Access level: 3
Func. diagram: 2804
Unit selection: -
Expert list: 1
Factory setting
-
0 signal FP
No 2804
No 2804
No 2804
No 2804
No -
No -
No -
No -
No -
1-601