Siemens SINAMICS S110 List Manual page 655

p20041 AND 2 run sequence / AND 2 RunSeq
CU_S110-CAN, Can be changed: T
CU_S110-DP,
Data type: Unsigned16
CU_S110-PN,
P-Group: -
SERVO_S110-CAN
Not for motor type: -
(FBLOCKS),
SERVO_S110-DP
(FBLOCKS),
SERVO_S110-PN
(FBLOCKS)
Min
0
Description: Setting parameter for the run sequence of instance AND 2 within the run-time group set in p20040.
Note: The function blocks with a lower run sequence value are calculated before function blocks with a higher run
sequence value.
p20042[0...3] BI: AND 3 inputs / AND 3 inputs
CU_S110-CAN, Can be changed: T
CU_S110-DP,
Data type: Unsigned32 / Binary
CU_S110-PN,
P-Group: -
SERVO_S110-CAN
Not for motor type: -
(FBLOCKS),
SERVO_S110-DP
(FBLOCKS),
SERVO_S110-PN
(FBLOCKS)
Min
-
Description: Sets the signal source of input quantities I0, I1, I2, I3 of instance AND 3 of the AND function block.
Index: [0] = Input I0
[1] = Input I1
[2] = Input I2
[3] = Input I3
r20043 BO: AND 3 output Q / AND 3 output Q
CU_S110-CAN, Can be changed: -
CU_S110-DP,
Data type: Unsigned32
CU_S110-PN,
P-Group: -
SERVO_S110-CAN
Not for motor type: -
(FBLOCKS),
SERVO_S110-DP
(FBLOCKS),
SERVO_S110-PN
(FBLOCKS)
Min
-
Description: Display parameter for binary quantity Q = I0 & I1 & I2 & I3 of instance AND 3 of the AND function block.
© Siemens AG 2012 All Rights Reserved
SINAMICS S110 List Manual (LH7), 06/2012, 6SL3097-4AP10-0BP3
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
32000
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
-
Calculated: -
Dynamic index: -
Units group: -
Scaling: -
Max
-
Parameter
List of parameters
Access level: 1
Func. diagram: 7210
Unit selection: -
Expert list: 1
Factory setting
30
Access level: 1
Func. diagram: 7210
Unit selection: -
Expert list: 1
Factory setting
0
Access level: 1
Func. diagram: 7210
Unit selection: -
Expert list: 1
Factory setting
-
1-655