Show Ip Static Route - Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.1 IPv4 protocol
Syntax
Call up the command with the following parameters:
show ip route[{<ip-address>[<mask>]|connected|ospf|static|summary}]
The parameters have the following meaning:
Parameter
ip-address
mask
connected
ospf
rip
static
summary
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The IPv4 routing table is displayed.
7.1.1.2

show ip static route

Description
This command shows the routes that were generated statically.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli>
Syntax
Call the command without parameters:
show ip static route
Result
The static routes are displayed.
260
Description
The destination address of the route.
Defines an address range using the
subnet mask.
Shows the network routes with a direct
connection.
Shows the OSPF entries in the routing
table.
Shows the RIP entries in the routing
table.
Shows the static routes in the table.
Shows a summary.
or
cli#
Range of values / note
Enter a valid IPv4 address
/8, /16 or /24
-
-
-
-
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10