Dhcp; Dhcp Client - Siemens SCALANCE XB-200 Configuration Manual

Procedure
1. Enable the "SMTP Client" option.
2. Enter the relevant e-mail address in the "Sender Email Address" input box.
3. If necessary send a test e-mail.
4. Enter the IP address of a the SMTP server in the "SMTP Server Address" input box.
5. Click the "Create" button. A new entry is generated in the table.
6. In the Receiver Email Address input box. enter the e-mail address to which the device
sends an e-mail if a fault occurs.
7. Click the "Set Values" button.
5.4.8

DHCP

5.4.8.1

DHCP Client

Setting of the DHCP mode
If the device is configured as a DHCP client, it starts a DHCP query. As the reply to the
query the device receives an IPv4 address from the DHCP server. The server manages an
address range from which it assigns IPv4 addresses. It is also possible to configure the
server so that the client always receives the same IPv4 address in response to its request.
SCALANCE XB-200/XC-200/XP-200 Web Based Management
Configuration Manual, 07/2016, C79000-G8976-C360-04
Configuring with Web Based Management
5.4 The "System" menu
107