show ip access-group
show ip access-group
Description
Display access control lists (ACLs) configured for each port on the controller.
Syntax
No parameters.
Examples
The example below shows part of the output of this command. If a port does not have a defined session ACL, the
Port-Vlan Session ACL table will be blank.
(host) # show ip access-group
FE 1/0:
Rx access list 200 is applied
session access list User14 is applied
Port-Vlan Session ACL
---------------------
SessionACL
----------
coltrane
The output of this command includes the following parameters:
Parameter
Session ACL
VLAN
Status
Related Commands
Command
interface fastethernet | gigabitethernetip access-group
Command History
Release
ArubaOS 3.0
ArubaOS 3.4
1062 | show ip access-group
Vlan
Status
----
------
22
configured
Description
Name of the ACL applied to the interface.
If the ACL was applied to a VLAN associated with this port, this column will show the VLAN ID.
Shows whether or not the session ACL is configured.
Modification
Command introduced
The VLAN output parameters was introduced.
Description
Configure an access group for an
interface.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide