Performing Event Logs (Trig); Table 3-3 Event Log Trigger Conditions - Agilent Technologies U1452A User Manual

The maximum number of readings that can be stored for the interval log
is 100 entries. When all entries are occupied,
press and hold
When the interval log recording session is running, all other keypad operations are
N O T E
disabled; the exception is
exit the recording session. Furthermore, APO (auto power-off) is disabled during the
recording session.

Performing event logs (TRIG)

Ensure that
option in the Setup.
Event logs are used only with the following
modes:
• TrigHold and AutoHold
• Earth- bond resistance tests
• Insulation resistance tests
• T/DAR/PI tests
Event records are triggered by the measured signal satisfying a trigger
condition set by the measurement function used in the following modes:

Table 3-3 Event log trigger conditions

Trigger condition
Modes
The input signal value is recorded:
Each time you press
TrigHold
update is stable.
When the input signal varies more than the
AutoHold
variation count and the reading update is stable.
U1452A/U1452AT/U1451A User's Guide
.
, which, when pressed for more than 1 second, will stop and

is selected as the Log
(page
(page
(page
(page 30)
and the reading
Recording Measurement Data (Log)

will be shown when you
55)
38)
38)
Primary display recorded
Voltage, resistance, or
capacitance
Voltage, resistance, or
capacitance
Tester Features
Secondary display
recorded
Voltage, frequency,
capacitance cable length,
or output source voltage
Voltage, frequency,
capacitance cable length,
or output source voltage
61
3