Connecting A Door Opener (Or Other Devices) To A Relay - Auerswald COMmander 6000 Advanced Information

Pbx for internet/isdn telephony

Hide thumbs Also See for COMmander 6000:

Table of Contents

Appendix Hardware

Connecting Devices to the 2TSM (R) Module

Further steps:

To finish commissioning, you need to configure the COMmander 2TMS

(R) module in the Configuration Manager and set up the corresponding

door terminal.

Connecting a Door Opener (or Other Devices) to a Relay

Warning: Power surges, which can occur during electrical

storms, can cause life-threatening electric shocks or damage

or destroy the PBX.

• Do not open an already connected PBX during an electrical

Requirements:

Installation cable (e. g. J-Y(St)Y 2x2x0.6) with the following character-

– At least two wires

– Unscreened; however: screened for unfavourable conditions, for

example, near a strong transmitter or an electrical power line

A door bell transformer as supply for the door opener (or the device to

be connected)

storm. Also avoid disconnecting and connecting electrical

lines during an electrical storm.

COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018

Commander 6000r