Appendix Hardware
Connecting Devices to the 2TSM (R) Module
Connecting a Door Terminal System in Accordance with FTZ 123
D12-0
Warning: Power surges, which can occur during electrical
storms, can cause life-threatening electric shocks or damage
or destroy the PBX.
• Hire a qualified electrician to lay the cables within the
Note: You will find wiring diagrams for the connection of
different door terminal systems to the PBX on the Internet
(see Auerswald: www.auerswald.de/service, FONtevo:
support.fontevo.com).
Requirements:
•
Installation cable (e. g. J-Y(St)Y 2x2x0.6) with the following character-
istics:
– At least three wires
– Unscreened; however: screened for unfavourable conditions, for
example, near a strong transmitter or an electrical power line
•
Door terminal system from Auerswald/FONtevo: Operating voltage
switched on at the relay contact to be used
2TSM Modul:
2TSM-R-Modul:
1. Lay the line.
1066
building.
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018