Shutting The Pbx Down By Pressing A Button - Auerswald COMmander 6000 Advanced Information

Appendix Hardware
Buttons
1. Press the Reset button (for COMmander 6000 on the base circuit
board; for COMmander 6000R/6000RX at the front of casing).
2. Press the SW default button (for COMmander 6000 on the base circuit
board; for COMmander 6000R/6000RX at the front of casing) within 2
seconds and hold it down between 10 and 15 seconds.
The Power LED starts to quickly blink in red.
After 5 seconds the LED Status starts to blink slowly.
3. Let go of the SW default button.
The factory settings are restored and the PBX restarts.
If the Power LED lights up in green again, the restart is complete and
the PBX is ready for operation.
Note:
If the Power LED remains continuously lit in red, an error has occurred.
Please contact your dealer or the manufacturer directly.
If you release the SW default button too late (the Power LED is no
longer flashing), restart the PBX without making any changes.

Shutting the PBX Down by Pressing a Button

Requirements:
• COMmander 6000R or 6000RX
• Delayed powering down: Press the Power button for 1,5 to 4 seconds.
1062
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018