Table of Contents
Advertisement
Appendix Hardware
Connecting Devices to the 2TSM (R) Module
Further steps:
•
To finish commissioning, you need to configure the COMmander 2TMS
(R) module in the Configuration Manager and set up the module as the
source of Music on Hold.
•
To save power, you can switch the power supply of the external input
device on and off using a relay of the PBX.
•
If required, you can modify the volume of the external Music on Hold
with the Volume Audio In control of the module.
Connecting a Loudspeaker for Announcements
Requirements:
•
Connecting cable with cinch connector
1. Connect the Audio Out cinch socket to the input socket of the
loudspeaker.
1080
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
Advertisement
Table of Contents
