Table of Contents
Advertisement
Connecting a Device for Alarm Functions
Warning: Power surges, which can occur during electrical
storms, can cause life-threatening electric shocks or damage
or destroy the PBX.
• Do not open an already connected PBX during an electrical
Warning: The alarm functions of the PBX do not comply with
the safety-related requirements regarding alarm systems for
the protection of life and limb.
• Only use the PBX for simple monitoring tasks without
Requirements:
•
Installation cable (e. g. J-Y(St)Y 2x2x0.6) with the following character-
istics:
– At least two wires
– Unscreened; however: screened for unfavourable conditions, for
example, near a strong transmitter or an electrical power line
1. Lay the lines.
2. Connect the But4/Klin4 terminal, for example, to the alarm contact.
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
storm. Also avoid disconnecting and connecting electrical
lines during an electrical storm.
safety-related requirements.
Connecting Devices to the 2TSM (R) Module
Appendix Hardware
1077
Advertisement
Table of Contents
