Connecting Devices To The 2Tsm (R) Module - Auerswald COMmander 6000 Advanced Information

Connecting Devices to the 2TSM (R)
Module
This section describes the connection of different devices to the 2TSM (R)
module.
Warning: Touching voltage-carrying conductors or phone
connections can cause life-threatening electric shocks.
• The PBX contains hazardous voltages, even outside the
• COMmander 6000: Pull out the power plug of the PBX
• COMmander 6000: Wait at least 3 minutes for the
Important: Improper use can cause, for example, functional restric-
tions or interference, the destruction of the device or, in a worst-case
scenario, personal injury.
• Only connect equipment that is compatible with the proper use of
the PBX.
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
power supply unit (for instance ringer voltages). Work on
active, contact-hazardous parts is only permitted after
creating a voltage-free state. Working close to active parts
is only permitted if these parts are voltage-free or are
protected against direct contact
before instructing a qualified electrician to open the casing
to install the expansion module or perform switching or
connecting services.
discharge of any capacitor in the device after disconnecting
it from the main power supply.

Connecting Devices to the 2TSM (R) Module

Appendix Hardware
1065