Appendix Hardware
Status Displays on the LEDs
Status Displays on the LEDs
LED functions on the base circuit board
The LED display field on the unit is used to keep track of the operating state.
Status LED:
Flashes red (50/50 ms) Pressing the SW default button is detected.
Flashes red (0,5/0,5 s) The SW default button was pressed long
Flashes orange (50/
50 ms)
Flashes orange (0,5/
0,5 s)
Status LED:
Lit in red
Lit in orange
Lit in green
Lit in green
Lit in green
Lit in green
1052
User prompt:
enough.
Pressing the SW altern. button is detected.
The SW altern. button was pressed long enough.
Power LED:
Lit in red
Lit in red
Lit in red
Lit in orange
Flashes orange The data base is being initialised/
Lit in green
COMmander 6000/R/RX - Firmware V7.0D - Advanced Information V19 04/2018
PBX status (after restart):
The boot partition is being tested.
The kernel is being loaded from the
partition.
The kernel is being initialised.
The kernel modules are being loaded.
converted.
The PBX is ready for operation.