Remove Small Form Pluggable Modules - Cisco Catalyst 8300 Series Hardware Installation Manual

Install and Upgrade Field Replaceable Units
Figure 31: Removing/Installing the fan tray
1
2

Remove Small Form Pluggable Modules

Follow these steps to remove a Small Form Pluggable (SFP) from the device:
Step 1 Read the Safety Warnings section and disconnect the power supply before you perform any module replacement.
Step 2
Disconnect all cables from the SFP.
Warning Statement 1051 Laser Radiation
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or
view directly with optical instruments.
Caution The latching mechanism used on many SFPs locks the SFP into place when cables are connected. Do not
pull on the cabling in an attempt to remove the SFP.
Step 3
Disconnect the SFP latch.
Screws
Fan tray
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
Remove Small Form Pluggable Modules
41