Replace Cisco NCS 1001 Components
Insert Optical Modules
Use this procedure to insert the optical modules.
Procedure
Step 1
Arrange the ejector lever of the optical module approximately at 60 degrees as shown.
Step 2
Push the module gently inside the slot (1, 2, or 3) with the ejector lever on top.
Step 3
Use the ejector lever force to push the module inside.
Step 4
When the ejector is aligned to the faceplate, fasten the captive screw in the clockwise direction to complete
the assembly.
Figure 46: Insert Optical Modules
1
2
Ejector lever
Captive screw
Hardware Installation Guide for Cisco NCS 1001
Insert Optical Modules
49