Table of Contents
Advertisement
Cisco Remote PHY Shelf 7200 Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
Note
The length of configurable limitation is 20 characters while there are 80 characters reserved.
Configure Downstream Controller Profile
To configure downstream controller profile, use the following commands:
configure terminal
cable downstream controller-profile <profile ID>
multicast-pool <id>
rf-chan 20 47
type video <SYNC | ASYNC>
frequency 231000000
max-carrier 150
rf-output NORMAL
qam-profile <profile ID>
The multicast-pool <id> defines the DEPI multicast group. The type video <SYNC | ASYNC> defines
synchronous or asynchronous mode.
Verify Downstream Controller Profile Configuration
To verify the Downstream controller profile configuration, use the show cable downstream controller-profile
command as shown in the following example:
Router#show running-config | section downstream controller-profile
cable downstream controller-profile 0
rf-chan 0 3
type DOCSIS
frequency 111000000
max-carrier 150
rf-output NORMAL
qam-profile 1
docsis-channel-id 1
Configure RPD for DS Controller Profile
To configure RPD for associating a downstream controller-profile, use the following commands:
configure terminal
cable rpd RPD01
type shelf
rpd-ds 0 max-carrier 150
rpd-ds 0 base-power 28
identifier 0004.9f31.0435
core-interface Te3/1/0
principal
rpd-ds 0 downstream-cable 3/0/0 profile 1
rpd-ds 0 downstream-cable 3/0/1 profile 2
rpd-us 0 upstream-cable 3/0/0 profile 1
core-interface te6/1/0
rpd-ds 0 downstream-cable 6/0/0 profile 2
r-dti 1
rpd-event profile 0
The rpd-ds 0 downstream-cable 3/0/0 profile 1 associates controller 3/0/0 with profile 1, which is a DOCSIS
profile.
Cisco Remote PHY Shelf 7200 Software Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
Configure Downstream Controller Profile
61
Advertisement
Table of Contents
